Are you tired of a dangling return line just flopping around when you have to pull your motor or work on your car? Say goodbye to those days of worrying of fuel spilling out, and getting dirt into your lines!
This bulkhead bracket slips right under the commonly used radium fuel filter setup and allows a 6AN return bulkhead to be fitted to the vehicle! This allows you to make a short return line which is easily removed whenever servicing is required.
Ground clearance hasn't been affected by this part either, and allows room for an OEM clutch line/bracket to be installed still as well! Bolt clearance is also maintained on the bracket that clamps the radium filter so there's no worry about being able to remove the filter at a later point!
Each one of these brackets is handmade, and thus may have some light scratches or other imperfections, please be advised we recommend to powdercoat or paint this bracket, but can be run in its raw form perfectly fine!
Please Note:
*no bulkhead parts are included - only longer mounting hardware to mount this and the radium fuel filter bracket to the chassis*