
Are you doing a single turbo swap? Don't want to burn up your heater hoses anymore? Well this is the solution for you! We take the factory 2JZGTE heater core hardline and we modify it with a 10AN stainless bung so you can use a normal AN fitting as well as weld on a new bracket to keep it bolted down tight.
Every single one of these it custom fit on a mock up motor to ensure 100% correct fitment when you go to bolt it up to your engine
We inspect every one prior to welding to ensure zero defects, ultrasonic clean them, and then purge the inside during welding.
This is an exchange service, so prior to ordering you must send in a core or contact us for other options. Or we can source a new OEM one to modify for you as well.
Optional:
We took the leg work out of the hose side of this project and offer a plug and play hose kit for these pipes as well! We use only genuine gates pre molded heater hoses, DEI heat sleeve to ensure it lasts longer, and we use Vibrant Performance hose ends. We also use a double pinch clamp setup that is tucked under the heat sleeve to ensure everything is protected!